Windows DatabaseebooksStatistical Information

LLE10171 : Howto reset a new HP Procurve switch to its factory defaults

Symptom:

You forgot your password or your ip address for administration

Cause:

none

Solution:

If you have forgotten the switch’s IP address or administration password you can return the switch to its factory default state by doing the following:

- Remove the power adapter from the back of the switch.
- Connect port 1 to port 2, on the front panel, using a standard network cable.
- Reconnect the power adapter to the rear of the switch.
- Wait at least 40 seconds before disconnecting port 1 from port 2.
- After completing this procedure, the password will be empty, the network address will be returned to the default 192.168.2.10, and all configuration settings will be returned to the original factory defaults.

Disclaimer:

The information provided in this document is intended for your information only. Lubby makes no claims to the validity of this information. Use of this information is at own risk!
Copyright © 2004-2011 Lubby (V3.0.10 Aug 2011)
Sponsored by Keskon.
Statistical information by Google Analytics